OPERATION 12.1.2 CHECK BEFORE STARTING Always carry out the items in this section before starting the engine each day. Check Coolant Level, Add Coolant WARNING Do not open the radiator cap unless necessary. When checking the coolant, always check the radiator reserve tank when the engine is cold. 1. Open the left rear cover on the machine and check that the coolant level is between the FULL and LOW marks on radiator reserve tank (1). If the coolant level is low, add coolant through the filler of reserve tank to the FULL level. 2. After adding coolant, tighten the cap securely. 3.
If the reserve tank becomes empty, first inspect for coolant leaks and then fill the radiator and reserve tank with coolant. For details of coolant to use; See 20 FUEL, COOLANT AND LUBRICANTS ACCORDING TO AMBIENT TEMPERATURE on page 3-9. Check Oil Level in Engine Oil Pan, Add Oil WARNING The turbocharger (with safety cover) exhaust manifold is near the dipstick (1), so be careful not to touch it. 1. Open the engine hood on the machine. 2. Remove dipstick (G) and wipe the oil off with a cloth. 3. Insert dipstick fully in the guide tube, then take it out again. 4. The oil level should be between the H and L marks on dipstick.
If the oil level is below the L mark, add engine oil through oil filler (F). For details of the oil to use;See 20 FUEL, COOLANT AND LUBRICANTS ACCORDING TO AMBIENT TEMPERATURE on page 3-9. 5. If the oil is above the H mark, drain the excess engine oil from drain plug, and check the oil level again. 6. If the oil level is correct, tighten the oil filler cap securely and close the engine hood. REMARK When checking the oil level after the engine has been operated, wait for at least 15 minutes after stopping the engine before checking. If the machine is at an angle, make it horizontal before checking. 2-45