OPERATION Check Fuel Level, Add Fuel WARNING When adding fuel, never let the fuel overflow. This may cause a fire. If you spill fuel, thoroughly clean up any spillage. 1. Use sight gauge (1) on the front face of the fuel tank to check that the tank is full. 2. If the fuel level is not within the sight gauge, add fuel through filler port (2) while watching sight gauge (1). Fuel capacity . . . . . . . . . . . . . . . . . . . . . . . . . . 340 R (89.8 gal) NOTICE For details of the fuel to use;See 20 FUEL, COOLANT AND LUBRICANTS ACCORDING TO AMBIENT TEMPERATURE on page 3-9. 3. After adding fuel, tighten the cap securely.
REMARK If breather hole (3) on cap is clogged, the pressure in the tank will drop and fuel will not flow. Clean hole from time to time. Check Oil Level in Hydraulic Tank, Add Oil WARNING ! When removing the oil filler cap, oil may spurt out, so turn cap slowly to release the internal pressure before removing the cap. ! If oil has been added to above the H mark, stop the engine and wait for the hydraulic oil to cool down, then drain the excess oil from the drain plug. 1.
If the work equipment is not in the position shown, start the engine, run the engine at low speed, retract the arm and bucket cylinders, then lower the boom, set the bucket teeth in contact with the ground, and stop the engine. 2. 15 seconds after stopping the engine, move each control lever (for work equipment and travel) to the full stroke in all directions to release the internal pressure. 3. Open the door on the right side of the machine. Check sight gauge (G). The oil level is normal if between H and L marks. NOTICE Do not add oil if the level is above the H line. This will damage the hydraulic equipment and cause the oil to spurt out. 4.
If the level is below the L mark, remove the upper cover of the hydraulic tank and add oil through oil filler (F). 2-46