3.3.10. Oil seal (Rear side) z Apply lubricating oil to the outside of the oil seal and flywheel housing inside diameter and fit them over the crank shaft, then assemble the oil seal using an oil seal fitting jig. Oil seal jig 3.3.11. Fly wheel z Installation of flywheel ring gear With a gas burner, heat the ring gear evenly until heat expansion takes place, then install it using a hammer. z Do not allow the temperature of the ring gear to exceed 200 ° C. z Assemble the wear ring using an assembly jig after coat the loctite #262 on it and heat it at the 150 ° C in the heater. z At the time assembling the wear ring, the direction of the cutting face of the circumference is the forward side.
z Install a guide bar into a bolt hole on the crank shaft, and lift the flywheel to align the dowel pin with the pin hole on the flywheel for temporary assembly operation. z Coat the adhesive (#587 Loctite) over the fixing bolts and install bolts in the remaining holes. After that take out the guide bar, then install a bolt in the hole where the guide bar had been inserted. DL06 Diesel Engine Disassembly and Reassembly of Major Components 101 Wear ring Ring gear