Common rail fuel injection Pm : Main injection pressure Ps : Max. injection pressure Injection pressure P P R (Pm) Time t z At the beginning of the injection process, the injected fuel quantity should be as low as possible (that is, during the ignition lag between the start of injection and the start of combustion) z The common rail system is a modular system, and essentially the following components are responsible for the injection characteristic. - Solenoid valve controlled injectors which are screwed into the cylinder head - Common rail - Fuel high pressure pump - Electric control unit(ECU) - Crankshaft speed sensor - Camshaft speed sensor 3.4.4.
Fuel high pressure pump z A radial-piston pump is used as the high pressure pump for pressure generation. Pressure is generated independently of the injection process. The speed of the high pressure pump is coupled directly to the engine speed with a non-variable transmission ratio. In comparison with conventional injection systems, the fact that delivery is practically uniform. z The injectors are connected to the common rail by high pressure pipe, comprise a nozzle, and a solenoid valve which is energized by the ECU to switch it on (start of injection), When the solenoid valve is switched off injection ceases.
DL06 Diesel Engine Disassembly and Reassembly of Major Components 122 Fuel injection