Doosan DL06 — Doosan DL06 User Manual

3.4.2. Major components of the common rail system 1) Electric control unit(ECU) 2) Crankshaft speed sensor 3) Camshaft speed sensor 4) Accelerator pedal sensor 5) Fuel temperature sensor 6) Boost pressure and temperature sensor 7) Common rail pressure sensor 8) Coolant temperature sensor 9) Oil pressure and temperature sensor z Using the input signals from the above sensors, the ECU registers the driver's requirements(accelerator pedal setting) and defines the instantaneous operating performance of the engine and the vehicle as a whole. On the basis of this information, it can then intervene with open and closed-loop controlling action at the vehicle and particularly at the engine.

z The engine speed is measured by the crankshaft speed sensor, and the camshaft speed sensor determines the firing sequence (phase length). The electrical signal generated across a potentiometer in the accelerator pedal module informs the ECU about how far the driver has depressed the pedal, the engine is equipped with a turbocharger and boost pressure control, the boost pressure sensor also z At low outside temperatures and with the engine cold, the ECU applies the data measures boost pressure. from the coolant temperature and air temperature sensors to adapt the set point values for start of the particular operating conditions. 3.4.3.

Injection characteristics with common rail z Injection characteristics with common rail, compared to conventional injection characteristics, the following demands are made up on an ideal injection characteristic, Independently of each other, injected fuel quantity and injection pressure should be definable for each and every engine operating condition. DL06 Diesel Engine Disassembly and Reassembly of Major Components 121