z Fuel high pressure pipe These fuel high pressure pipes carry the high pressure fuel of up to 1600bar. They must therefore be able to permanently withstand the maximum system pressure and, during the pauses in injection, the sometimes high frequency pressure fluctuations which occur. They are therefore manufactured from the high pressure pipe. They have an outside diameter of 8.0 mm and an internal diameter of 3.0 mm. The fuel high pressure pipe lines between the common rail and the injectors must all be of the same length, should be kept as short as possible. 3.4.11.
Construction of the fuel high pressure pump 1) Function The high pressure pump is the interface between the low-pressure and the high pressure stages. Under all operating conditions, it is responsible for providing adequate high pressure fuel throughout the vehicle's complete service life. This also includes the provision of extra fuel as needed for rapid starting and for rapid build-up of pressure in the rail. The high pressure pump continually generates the system pressure as needed in the common rail. 2) Construction of the fuel high pressure pump The fuel is compressed with three radially arranged pump pistons which are at an angle of 120° to each other.
Since three delivery strokes take place for every revolution, only low peak drive torques are generated so that the stress on the pump drive remains uniform. The driving torque of the common rail is only about 1/9 of torques to drive existing pump system. 3) Method of operation The fuel supply pump fuel from the tank to the high pressure pump through the fuel inlet and the safety valve. It forces the fuel through the safety valve into the high pressure pump. The driveshaft with its eccentric cams moves the piston of the pump up and down in accordance with the shape of the cam.
As soon as the delivery pressure exceeds the safety valve's opening pressure (0.5 ~ 0.5 bar), the fuel supply pump can force fuel through the high pressure pump's inlet valve into the pumping-element chamber whose pump piston is moving downwards(suction stroke). The inlet valve closes when the pump piston passes through the bottom dead center (BDC) and, since it is impossible for the DL06 Diesel Engine Disassembly and Reassembly of Major Components 125