4) Injector closes (end of injection) As soon as the solenoid valve is no longer triggered, the valve spring forces the armature downwards and the ball closes the bleed orifice. The armature is a 2- piece design. Here, although the armature plate is guided by a driver shoulder in its downward movement, it can "over spring" with the return spring so that it exerts no downwards-acting forces on the armature and the ball. The closing of the bleed orifice leads to pressure buildup in the control chamber via the input from the feed orifice. This pressure is the same as that in the rail and exerts an increased force on the control plunger through its end face.
This force, together with that of the spring, now exceeds the force exerted by the chamber volume and the nozzle needle closes. The nozzle needle's closing speed is determined by the flow through the feed orifice. Injection ceases as soon as the nozzle needle comes up against its bottom stop again. 3.4.14. Crank shaft speed sensor z The piston position in the Fixing Bolt combustion chamber is decisive in defining the start of injection. All Crank Shaft Sensor the engine's pistons are connected to the crankshaft by connecting rods. A sensor on the crankshaft Shim can therefore provide information on the position of all the pistons.
The rotational speed defines the number of crankshaft rotations per minute. This important input variable is calculated in the ECU using the signal from the inductive crankshaft speed sensor. DL06 Diesel Engine Disassembly and Reassembly of Major Components 131