3.4.15. Cam shaft speed sensor z The camshaft controls the engine's intake and exhaust valves. It turns Fixing Bolt at half the speed of the crankshaft. When a piston travels in the Crank Shaft Sensor direction of TDC, the camshaft position determines whether it is in Shim the compression phase with subsequent ignition, or in the exhaust phase. This information cannot be generated from the crankshaft position during the starting phase. During normal engine operation on the other hand, the information generated by the crankshaft sensor suffices to define the engine status.
In other words, this means that if the camshaft sensor should fail while the vehicle is being driven, the ECU still receives information on the engine status from the crankshaft sensor. 3.4.16. Accelerator pedal sensor z The accelerator pedal sensor transmitted the driver’s acceleration input to the ECU. z A voltage is generated across the potentiometer in the accelerator-pedal sensor as a function of the accelerator-pedal setting. Using a programmed characteristic curve, the pedal's position is then calculated from this voltage. 3.4.17.
Boost pressure & temperature sensor z The boost pressure & temperature sensor are connected to the intake Fixing bolt Boost pressure & temperature sensor manifold by the O-ring and measures the intake manifold's absolute pressure and temperature. Shim z The output signal is inputted to the ECU where, with the help of a programmed characteristic curve, it is used for calculating the boost pressure. DL06 Diesel Engine Disassembly and Reassembly of Major Components 132