z At the end of the break-in period, remove break-in oil and replace the oil filter. z Fill oil pan with recommended engine oil. Refer to following table z Engine oil capacity 4.2.3. Operating after break-In When starting a cold engine, always allow the engine to warm up gradually. Never run the engine at full throttle until the engine is thoroughly warmed up. Be sure to check the oil level frequently during the first 5,000km (500Hr) of operation, since the oil consumption will be high until the piston rings are properly seated. 4.3. Inspections after Starting During operation the oil pressure in the engine lubrication system must be monitored.
If the monitoring devices register a drop in the lube oil pressure, switch off the engine immediately. And the charge warning lamp of the alternator should go out when the engine is running. z Do not disconnect the battery or pole terminals or the cables. z If, during operation, the battery charge lamp suddenly lights up, stop the engine immediately and remedy the fault in the electrical system. z Engine should be stopped if the color, the noise or the odor of exhaust gas is not normal. z Confirm the following things through warning lamps and gauge panel. DL06 Diesel Engine Commissioning and Operation 158 SAE no.
Oil grade 10W40 ACEA-E5 (API CI-4) Engine oil capacity Engine model Oil pan inside Total (lit) Use Suffix Max (lit) Min (lit) Truck EUTCA 19 15 21 Excavator EUTEA/C/F/G/H/I 27 17 29 EUTEB/D/J/K/L 22 16 24 EUTLA/B/C/D 27 20 29 Fork lift EUTFA/B/C/D 27 17 29