Doosan DL06 — Doosan DL06 User Manual

4.3.1. Pressure of lubricating oil The normal pressure comes up to 1.5 ~ 3 kg/cm 2 at idling and 3.0 ~ 5.5 kg/cm 2 at maximum speed. If the pressure fluctuates at idling or does not reach up to the expected level at high speed, shut down the engine immediately and check the oil level and the oil line leakage. 4.3.2. Temperature of cooling water The cooling water temperature should be 85 ° C in normal operating conditions. Abnormally high cooling water temperature could cause the overheating of engine and the sticking of cylinder components. And excessively low cooling water temperature increases the fuel consumption, accelerates the wears of cylinder liners and shortens the engine life-time.

4.3.3. Over-speed control The electric control unit (ECU) have a system of preventing the engine over-speed among many system. This system involve many function of fuel flow control, ignition time delay, fuel shut off, and ignition shut off etc. These values are set up in advance in the memory of the ECU, and should not be revised by user. This engine with ECU should not be run at the over-speed rating speed for a regular time, if the vehicle is speeded, the fuel and ignition is shut off until the engine speed is up to the proper level. DL06 Diesel Engine Commissioning and Operation 159