z Knocking out dirt by hand - In emergencies, when no compressed air or cleaning agent is available, it is possible to clean the filter cartridge provisionally by hitting the end disk of the cartridge with the ball of one's thumb. - Under no circumstances should the element be hit with a hard object or knocked against a hard surface to loosen dirt deposits. z Checking the air cleaner cartridge - Before reinstalling the cartridge, it must be checked for damage e.g. to the paper pleats and rubber gaskets, or for bulges and dents etc. in the metal jacket. - Damaged cartridges should not be reused under any circumstances. In cases of doubt, discard the cartridge and install a new one. 5.5.
Belt The tension of the belts should be checked after every 2,000 hours of operation. (1) Change the belts if necessary If in the case of a multiple belt drive, wear or differing tensions are found, always replace the complete set of belts. (2) Checking condition Check belts for cracks, oil, overheating and wear (3) Testing by hand z Poly belt Poly belt will be properly tensioned if the deflection force “F” is applied mid-way between the belt’s tangent points with the pulley. DL06 Diesel Engine Maintenance of Major Components 187