z Engine assembly tolerance (unit :
mm) DL06 Diesel Engine Special Tool List 196 Group Part Inspection item Stand value for assembly Limit for use Correction Remark Cylinde r block Cylinde r block & liner Inside diameter of cylinder liner φ104.9~φ105.1 φ104.4 Replace liner Measure unworn portion beneath the rim of the upper side Amount of liner projection 0.03 ~ 0.08 - From top of cylinder The flatness of upper surface of cylinder block 0.08 - Correct with a surface grinder Referenced length 200mm Hydraulic test for 1 Minute (kg/cm2) 4 - Replace if leaky Cylinde r head & valve Valve seat depression Intake 0.35 ~ 0.65 0.85 Replace valve seat Depression of valve from lower face of cylinder head Exhaust 0.35 ~ 0.65 0.85 Cylinder head height 104.9~105.1 104.4 Replace cylinder head The flatness of lower surface of cylinder head 0.15 0.3 Replace cylinder head Thick of cylinder head gasket(at assembly status) 1.215~1.285 - Hydraulic test for 1 minute (bar) 4 - Replace if leaky Water temperature 70°C Major moving parts Piston Outer diameter of piston φ99.93~φ99.952 - Replace liner Measure at 8 mm away from piston head(long diameter) Clearance between piston and liner 0.079 ~ 0.101 0.3 Replace one worn more Inner diameter of piston pin side φ40.006~φ40.01 - 4 Width of piston ring grooves Top ring - - Replace piston if groove width is beyond specified Measure at φ105mm of top ring groove 2nd ring 2.54~2.56 - Oil ring 4.02~4.04 - Piston projection from cylinder block upper surface 0.206 ~ 0.558 - Measure unworn portion beneath the rim of the upper side Permissible weight difference of each piston 30g 30g↓ Replace piston Piston ring Width of piston ring Top ring - - Replace ring 2nd ring 2.47~2.49 - Oil ring 3.97~3.99 - Piston ring gap Top ring 0.30~0.45 1.5 Replace ring Standard gauge inside diameter:
2nd ring 0.60~0.80 1.5