Doosan DL06 — Doosan DL06 User Manual

(Unit :

mm) DL06 Diesel Engine Special Tool List 198 Group Part Inspection item Stand value for assembly Limit for use Correction Remark Major moving parts Crank shaft Radial run-out of journal and pin - 0.01 Correct with a grinder Horizontal and vertical directions Outside diameter of journal φ79.905~φ79.925 φ78.905 Use under sized bearings respectively (0.25, 0.5, 0.75, 1.0) Outside diameter of pin φ68.924~φ68.944 φ67.92 4 With of thrust journal 33.99 ~ 34.03 33.94 Ellipticity of journal and pin 0.007 0.025 Concentricity of journal and pin 0.02 0.03 Taper of journal and pin 0.02 0.03 Run-out of crankshaft 0.06↓ 0.1↓ Adjust by a press Measure #4 journal (journal #1, #7 support) Clearance between crankshaft and bearing 0.045~0.110 0.15 Replace bearings Measure at crown part End play of crankshaft 0.14~0.33 0.4 Replace thrust bearing Measure at crown part Balance of Crankshaft (g.cm) 60 ↓ 60 or Check dynamic balance Measure at 400 rpm less Torque of Journal bearing cap bolt (kg.m) 30±2 - Coat the bolt with engine oil Clean out foreign objects on joining surface.

Crush of journal diameter 0.065 ~ 0.105 - Measure after tightening metal cap and releasing one bolt Oil seal for wear (crank shaft rear) - - Replace oil seal if oil leaking Connectin g rod Inner diameter of small-end φ40.03 ~ φ40.04 - Inner diameter of big- end φ73.000~φ73.015 - End play of con-rod 0.170 ~ 0.30 0.50 Clearance between con-rod bearing and crank pin 0.030 ~ 0.081 0.15 Replace con- rod Clearance between small end bush & piston pin 0.03 ~ 0.046 0.08 Replace bearing Crush height of con-rod bearing 0.085 ~ 0.125 - Measure after installing the bearing and releasing one bolt Perpendicularity of big- end inner diameter 0.05 0.1 Roundness of big-end inner diameter 0.007 0.25 Parallelness of small end side and big end 0.2 0.50 Replace con- rod Allowable weight difference per con-rods 10g ↓ - Replace same degree Management of con-rod’s grade (A ~I)