5) Assembling cylinder head z Clean the cylinder head thoroughly. Replace the valve Valve guide stem seal with new one, and by means of a special tool, press the stem seal into the valve guide of cylinder head. z Coat engine oil to valve stem Valve seat and valve guide and assemble the valve. However, be careful for the damage of valve stem z Install the lower seat of valve spring to the valve guide of cylinder head. seal. z After putting inner, outer springs, install the spring upper Painted portion (Assemble spring to the upper side) seat on it. z Assemble the valve by inserting the valve cotter pressing the valve spring with a special tool.
z After installing the valve, check whether the valve is correctly installed or not tapping it lightly with urethane hammer. 3.2.3. Rocker arm (1) Disassembly 1) Disassemble the snap rings that are located at one end of rocker arm shaft by a plier. 2) Disassemble in the order of washer, rocker arm, rocker arm bracket, rocker arm spring. DL06 Diesel Engine Disassembly and Reassembly of Major Components 76