(2) Inspection of rocker arm assembly 1) Rocker arm shaft z Rocker arm shaft run-out Place the rocker arm shaft on two V-blocks and inspect the shaft for bend using a dial gauge. If the amount of this run-out is small, press the shaft with a bench press to correct the run- out. Replace the shaft if the measured value exceeds the limit. z Rocker arm shaft diameter With an outside micrometer, measure the rocker arm shaft diameter at the point where the rocker arms have been installed. Replace the rocker arm if the Rocker arm shaft amount of wear is beyond the specified limit.
DL06 Diesel Engine Disassembly and Reassembly of Major Components 77 Limit 0.1 mm Standard Limit φ24.939 ∼ φ24.960 mm φ24.90 mm