Doosan DL06 — Doosan DL06 User Manual

4) Rocker arm assembly z Reassembling can be done in the reverse order of disassembling and following things should be heeded. z Check the oil supply hole of rocker arm shaft for any clog and clean thoroughly. z Be careful, not to occur any swap of position and reverse assembly. 3.2.4. Camshaft (1) Camshaft end play z Push the camshaft gear toward z With a feeler gauge, measure the opposite cylinder block. the clearance between the thrust plate and camshaft gear. z If the end play is excessive, Feeler gauge replace the thrust plate. (2) Cam z Use a micrometer to measure the cam lobe height and journal diameter.

z If the measured number is less than the specified limit, the camshaft must be replaced. C B B A D A Limit 47.48 mm 45.73 mm φ 55.65 mm DL06 Diesel Engine Disassembly and Reassembly of Major Components 80 Standard Limit 0.280 ~ 0.430 mm 0.5 mm Standard Cam lobe height (C) Intake 46.025 mm Exhaust 47.782 mm Cam journal diameter (A,B) φ55.92∼φ55.95mm