z Inspect the cam face for z Slight step wear or damage on scratch or damage. the cam face may be corrected with oil stone or oiled grinding paper. But, replace if severely damaged. (3) Between camshaft journal and camshaft bush z With an outside micrometer, measure the camshaft journal z Measure the inside diameter of diameter. the camshaft bushing on the cylinder block using a cylinder bore indicator, and compare Camshaft bearing the measured value with the camshaft outside diameter to determine the clearance. z Replace the bushing if the measured value is beyond the specified limit. (4) Cam shaft run-out z Support the camshaft on two V- blocks and check for run-out using a dial indicator.
Correct or replace the cam shaft if the amount of run-out is beyond the value indicating need for servicing. DL06 Diesel Engine Disassembly and Reassembly of Major Components 81 Standard Limit 0.03 ∼ 0.09 mm 0.18 mm