3.2.5. Crankshaft (1) Inspection of crankshaft 1) Defect check z By naked eyes, check for any scratch or damage on the crankshaft journal and crank pin. z By means of magnetic particle test and color check, check the crankshaft for any crack and if found, replace it. 2) Wear measuring z With an outside micrometer measure the diameter of the crankshaft journals and pins in the directions as shown, and compare the measured values to determine the amount of wear. z If the amount of wear is beyond the limit, have the A crankshaft ground and install B B undersize bearings.
However, B B if the amount of wear is within the limit, you can correct the wear using an oil stone or oiled grinding paper of fine grain A size. (Be sure to use grinding paper which has been immersed in oil.) DL06 Diesel Engine Disassembly and Reassembly of Major Components 82 Standard Limit 0.05 mm 0.15 mm