Doosan DL06 — Doosan DL06 User Manual

z In case that pin's wear is more than the limit value, grind the crankshaft journal and crank pin, and use the undersized bearings. z Be sure to use grinding paper which has been immersed in oil. Normal Poor Poor "R" part's specified value ① Crank pin's "R" : 3.3~3.7 ② Crank Journal "R" :

3.3~3.7 ‹ Standard ‹ 0.25 (Inside diameter is 0.25 mm lesser than the standard size) ‹ 0.50 (Inside diameter is 0.50 mm lesser than the standard size) ‹ 0.75 (Inside diameter is 0.75 mm lesser than the standard size) ‹ 1.00 (Inside diameter is 1.00 mm lesser than the standard size) Undersize bearings are available in 4 different sizes as indicated above, and the crankshaft can be reused through the regrinding as described above . CAUTION : In case of regrinding, the grinding the "R" part of bearing end should be correctly done and avoid sharp corners or insufficient fillet.

DL06 Diesel Engine Disassembly and Reassembly of Major Components 83 Standard Limit Journal diameter φ79.905∼φ79.925mm φ78.905 mm Pin diameter φ68.924∼φ68.944mm φ67.924 mm