3.3. Reassembly 3.3.1. General precautions z Clean all the disassembled parts, particularly oil and water ports, using compressed air, then check that they are free from restrictions. z Arrange the general and special tools in order for engine assembly operation. z To wet each sliding part, prepare the clean engine oil. z Prepare service materials such as sealant, gaskets, etc. z Discard used gaskets, seal rings, and consumable parts, and replace with new ones. z Apply only the specified torque for bolts in the specified tightening order and avoid z Be sure to check that all the engine parts operate smoothly after being over-tightening. reassembled.
z Check the bolts for looseness after reassembly. z After completing the engine reassembly operation, check if there is missing parts or shortage of parts. z Keep your hands clean during the working. 3.3.2. Cylinder block z Cover the floor of the workshop with wood plate or thick paper to prevent damage to the cylinder head and place the cylinder block with the head fitting surface facing downward. 3.3.3. Cylinder liner z Stand the cylinder block so that the flywheel faces downward. z Thoroughly clean the liner flange fitting surface and bore inside with compressed air to prevent the entry of foreign substances. DL06 Diesel Engine Disassembly and Reassembly of Major Components 94