z Install the bearing and thrust washers to the bearing cap and apply oil to the bearing and thrust washers. z Install the bearing cap by matching the cylinder block No. with the bearing cap No. Apply oil to the entire part of the bearing cap bolts, then tighten in tightening sequence to specified torque. z After semi-tightening both bolts evenly, tighten them diagonally to the specified torque using a torque wrench as follows. (1) First stage : Coat the cap bolts with engine oil (2) Second stage : Temporary bolt screwing about 1 ~ 2 threads (3) Third stage : With impact wrench, tighten up to about 15 kg.m (4) Fourth stage : With torque wrench, tighten up to about 25 kg.m (5) Fifth stage :
By means of torque wrench, tighten finally in the specified torque. (30 ± 2 kg.m). DL06 Diesel Engine Disassembly and Reassembly of Major Components 97 Torque 30±2 kg.m