Mack Trucks — Mack RH Drive Australia 21630923 Manual

126 OPERATION Shutting Down the Engine After a hard run, allow the engine to idle three minutes before shutdown to stabilize the temperature of all engine parts. Quick shutdowns can cause engine damage and prevent the turbocharger from being properly lubricated. For additional options, see “Shutting Down the Engine”, page 130. General Observation Make it a habit at stops to walk around your truck and look for fuel, oil and coolant leaks. Also check the condition of tyres, wheel nuts, springs and lights. Stop trouble before it stops you!

STARTING THE VEHICLE General Information Before putting the key in the ignition switch, set the parking (spring) brake, disengage the clutch (if equipped) and put the transmission in NEUTRAL. CAUTION CAUTION Do not engage the starting motor too soon after an incomplete start of the engine, or the starter may be damaged. Wait at least five seconds before attempting to restart the engine. If the engine does not start immediately, limit cranking periods to 30 seconds to avoid overheating and damaging the starter. CAUTION Do not rev the engine at start-up. Turbocharger damage may result because lubricants need time to establish a film between moving parts.

WARNING Make sure clutch is depressed and transmission is in neutral before engaging the starter! Failure to do so could cause the vehicle to jerk forward unexpectedly causing serious damage or bodily harm.