OPERATION 127 Starting MP Engines Use the following procedure: 1. Crank the engine until it starts. Note: Do NOT apply the throttle pedal during engine cranking. CAUTION DO NOT engage the starting motor too soon after an incomplete start of the engine, or the starter may be damaged. Wait at least five seconds before attempting to restart the engine. If the engine does not start immediately, limit cranking periods to 30 seconds to avoid overheating and damaging the starter. DO NOT rev the engine at start-up. Turbocharger damage may result. Lubricants need time to establish a film between moving parts. 2.
After the engine has started, warm the engine until the coolant temperature reaches normal operating range (77°C to 107°C; 170°F to 225°F). Once the engine reaches this temperature, it can be operated in a normal fashion. Note: Warm-up time can be reduced by increasing engine idle speed between 1000 and 1200 rpm by either applying the throttle pedal or by using the Electronic Hand Throttle feature (if equipped). Note: For bobtail or unloaded applications, the engine may be warmed up by moving the vehicle with "light" throttle application after only one minute of idle.
Priming the MP Fuel System DANGER Before working on or inspecting a vehicle, set the parking brakes, place the transmission in neutral and block the wheels. Failure to do so can result in unexpected vehicle movement and can cause serious personal injury or death.