Mack Trucks — Mack RH Drive Australia 21630923 Manual

54 INSTRUMENTS AND CONTROLS 38. Secondary Air Pressure Gauge – Indicates the air pressure in the secondary air brake system. Secondary air pressure is supplied to the steering axle brakes.The normal operating air pressure is between 759 kPa (110 psi) and 897 kPa (130 psi). If pressure drops below 517 kPa (75 psi) ±34 (± 5 psi), the warning buzzer and warning light will go on. Determine the cause of failure before proceeding. 39. Primary Air Pressure Gauge – Indicates the air pressure in the Primary air brake system. Primary air pressure is supplied to the rear brakes. The normal operating air pressure is between 759 kPa (110 psi) and 897 kPa (130 psi).

If pressure drops below 517 kPa (75 psi) ±34 (± 5 psi), the warning buzzer and warning light will go on. Determine the cause of failure before proceeding. 41. Hand-Control Brake Lever – Pull down to activate the trailer brakes, or the rear axle brakes in the case of a platform truck. 43. Optional Switch – Refer to “Function of Optional Switches”, page 58 42. Optional Switch – Refer to “Function of Optional Switches”, page 58 45. Optional Switch – Refer to “Function of Optional Switches”, page 58. 44. Optional Switch – Refer to “Function of Optional Switches”, page 58. 46. Heated Mirror Defrost Switch – Defrost the mirrors 47. Engine Brake Switch 48.

Resume/Set Switch This is a V-MAC® switch; refer to the V-MAC® IV Vehicle Management and Control with Co-Pilot® Display Operator’s Guide for more information. 49. CB Radio (If Equipped) (Cummins) 49. m DRIVE Automatic Transmission Selector (If Equipped) See your m DRIVE Transmission Operator’s Manual supplied with this vehicle. 50. Air Filter Restriction Indicator (If Equipped) Indicates that the element needs servicing or replacement. When the red flag locks into position, service as soon as possible to prevent engine damage; then reset the indicator after the filter change. Check the air filter restriction indicator daily. 51.

Accessory Power Outlet – See instructions under Accessory Power Outlets listed in the Instrument and Controls Section of this manual. WARNING The hand-control brake system must NOT be used for parking. Do NOT use to apply service brakes while vehicle is in motion. Do not leave the vehicle while hand-control brake is applied.