38 GETTING TO KNOW YOUR VEHICLE When enabled in Uconnect Settings, Easy Entry and Easy Exit positions are stored in each memory setting profile Ъ page 33. Front Heated Seats Rear Heated Seats The heated seats control buttons are located on the center instrument panel below the touchscreen, and are also located within the climate or controls screen of the touchscreen. On some models, the two outboard rear seats are equipped with heated seats. The heated seat switches for these seats are located on the rear of the center console. NOTE: The Easy Entry/Exit feature is enabled or disabled through the programmable features in the Uconnect system Ъ page 231. H EATED S EATS — I F E QUIPPED NOTE:
If the vehicle is equipped with a 12-inch radio, there will only be control buttons through the touchscreen. There are two heated seat switches that allow the rear passengers to operate the seats independently. You can choose from HI, MED, LO, or OFF heat settings. Amber indicator lights in each switch indicate the level of heat in use. On some models, the front and rear seats may be equipped with heaters located in the seat cushions and seatbacks. Push the heated seat button once to turn the HI setting on. Push the heated seat button a second time to turn the MED setting on. Push the heated seat button once to turn the HI setting on.
Persons who are unable to feel pain to the skin because of advanced age, chronic illness, diabetes, spinal cord injury, medication, alcohol use, exhaustion or other physical condition must exercise care when using the seat heater. It may cause burns even at low temperatures, especially if used for long periods of time. WARNING! Push the heated seat button a third time to turn the LO setting on. Push the heated seat button a second time to turn the MED setting on. Push the heated seat button a third time to turn the LO setting on. Push the heated seat button a fourth time to turn the heating elements off. Push the heated seat button a fourth time to turn the heating elements off. NOTE:
The engine must be running for the heated seats to operate. NOTE: Do not place anything on the seat or seatback that insulates against heat, such as a blanket or cushion. This may cause the seat heater to overheat. Sitting in a seat that has been over- heated could cause serious burns due to the increased surface temperature of the seat. The level of heat selected will stay on until the operator changes it. The level of heat selected will stay on until the operator changes it. Once a heat setting is selected, heat will be felt within two to five minutes. For information on use with the Remote Start system, see Ъ page 24. The engine must be running for the heated seats to operate.