50 GETTING TO KNOW YOUR VEHICLE Reprogramming A Single HomeLink® Button (Canadian/Gate Operator) M ULTIFUNCTION L EVER To reprogram a channel that has been previously trained, follow these steps: The multifunction lever is located on the left side of the steering column. 1. Place the ignition in the ON/RUN position. 2. Press and hold the desired HomeLink® button until the indicator light begins to flash after 20 seconds. Do not release the button. 3. Without releasing the button, proceed with “Canadian/Gate Operator Programming” step 2 and follow all remaining steps.
Headlight Switch Multifunction Lever EXTERIOR LIGHTS 1 — Rotate Headlight Control 2 — Push Fog Light Switch 3 — Ambient Light Dimmer Control 4 — Instrument Panel Dimmer Control 5 — Push Cargo Light Switch D AYTIME R UNNING L IGHTS (DRL S ) — I F E QUIPPED H EADLIGHT S WITCH The Daytime Running Lights (DRLs) come on whenever the engine is running, and the low beams are not on. The lights will remain on until the ignition is placed in the OFF or ACC position, or the parking brake is engaged. The headlight switch is located on the left side of the instrument panel.
This switch controls the operation of the headlights, parking lights, automatic headlights (if equipped), instrument panel light dimming, cargo light/trailer spotter lights (if equipped), and fog lights (if equipped). To turn on the headlights, rotate the headlight switch clockwise. When the headlight switch is on, the parking lights, taillights, license plate light and instrument panel lights are also turned on. To turn off the headlights, rotate the headlight switch back to the O (off) position. NOTE: For vehicles sold in Canada, the Daytime Running Lights will automatically deactivate when the front fog lights are turned on.
If allowed by law in the country in which the vehicle was purchased, the Daytime Running Lights can be turned on and off using the Uconnect system Ъ page 231. On some vehicles, the Daytime Running Lights may deactivate, or reduce intensity, on one side