GETTING TO KNOW YOUR VEHICLE 51 of the vehicle (when a turn signal is activated on that side), or on both sides of the vehicle (when the hazard warning lights are activated). H IGH /L OW B EAM S WITCH the vehicle). Also, dirt, film, and other obstruc- tions on the windshield or camera lens will cause the system to function improperly. D IRECTIONAL LED H EADLAMP S YSTEM F E QUIPPED If the windshield or Automatic High Beam Head- lamp Control mirror is replaced, the mirror must be re-aimed to ensure proper performance. See a local authorized dealer. This is a system consisting of LED (low/high beam) headlights that incorporate dynamic cornering with 5-degree inboard/15-degree outboard swivel.
The headlights continuously and automatically adapt to the driving conditions around bends or when cornering based on steering wheel angle. Push the multifunction lever toward the instrument panel to switch the headlights to high beams. Pulling the multifunction lever back will turn the low beams on. A UTOMATIC H IGH B EAM H EADLAMP C ONTROL — I F E QUIPPED 2 The Automatic High Beams will not activate until the vehicle is at or above 15 mph (24 km/h). F LASH -T O -P ASS The system directs the headlights to light up the road in the best way, taking into account the speed of the vehicle and the bend or corner angle, as well as the speed of the vehicle while the steering wheel is being turned.
The Automatic High Beam Headlamp Control system provides increased forward lighting at night by automating high beam control through the use of a camera mounted on the inside rearview mirror or a windshield mounted camera. These cameras detect vehicle specific light and automatically switch from high beams to low beams until the approaching vehicle is out of view. You can signal another vehicle with your headlights by lightly pulling the multifunction lever toward you. This will cause the high beam headlights to turn on, and remain on, until the lever is released.
A UTOMATIC H EADLIGHTS — I F E QUIPPED The adaptive lights are automatically activated when the vehicle is traveling above approximately 5 mph (8 km/h). This system automatically turns the headlights on or off according to ambient light levels. To turn the system on, rotate the headlight switch to the AUTO position. This system can be turned on/off through the Uconnect Settings under “Steering Directed Lights” Ъ page 231. P ARKING L IGHTS A ND P ANEL L IGHTS NOTE: The Automatic High Beam Headlamp Control can be turned on or off by selecting “ON” under “Auto Dim High Beams” within your Uconnect Settings Ъ page 231, as well as turning the headlight switch to the AUTO position.
When the system is on, the Headlight Delay feature is also on. This means the headlights will stay on for up to 90 seconds after you place the ignition into the OFF position. To turn the automatic headlights off, turn the headlight switch out of the AUTO position. To turn on the parking lights and instrument panel lights, rotate the headlight switch clockwise. To turn off the parking lights, rotate the headlight switch back to the O (off) position. Broken, muddy, or obstructed headlights and taillights of vehicles in the field of view will cause headlights to remain on longer (closer to NOTE: The engine must be running before the headlights will turn on in the Automatic Mode.