TROUBLE SHOOTING GUIDE TROUBLE SHOOTING GUIDE This guide is not intended to cover every conditions, however many of the more common possibilities are listed. ELECTRICAL SYSTEM speed. Lamp does not glow brightly even when engine runs at high The starting motor disengages before the engine starts up. l Check and repair the wiring. Lamp flickers while engine runs. l Check for loose terminals and open-circuit wiring. l Charge the battery. l Replace fan belt. The engine pre-heating monitor does not flash. l Check and repair wiring. speed. Charge monitor does not go out even when engine runs at high l Replace the heater relay. l Replace the monitor. l Inspect and repair wiring. .
Replace the alternator. The engine oil pressure monitor does not light up when engine Unusual noise is emitted from the alternator. is stationary (when the starting switch is in ON position.) l Replace the monitor. l Replace the alternator. l Repair or replace the sensor. . Check wiring. Starting motor does not turn when starting switch is turned on l Inspect and repair the wiring. Charge monitor does not light up when the engine is stationary. (When the starting switch is in ON position.) The pinion of the starting motor keeps going in and out. l Charge the battery. l Replace the monitor. l Inspect and repair the wiring. l Charge the battery.
Outside the glow plug is not warm when touched with the hand. Starting motor turns the engine sluggishly. l Charge the battery. l Check and repair wiring. l Replace the glow plug. l Replace the starting motor. l Check and repair the pre-heater switch. - 120- W-02107