ADJUSTMENT FAN BELT AND TENSIONER Method of replacement Loosen lock nut (2). then loosen Adjustment procedure If noise comes from the belt, tighten adjustment bolt (3) to make A dimension 80 mm, and lock in po- bolt (3). Push the tension pulley (I) in the 3mm * II I 6 direction of arrow to a position sition with lock nut (2). + Tightening torque: 38 kgm Ir When the belt is new, A dimen- sion is about 100 mm. where the belt can be removed, then replace the belt. * When changing belts, do not only change one belt. Always change as a set. Check the lining for wear and re- place the pad, if the thickness of the lining is reduced to less than 3 mm.
* Ask your Komatsu distributor for replacement of the pad. A Take care not to stain the brake pad and the disc surface with oil or grease. w-04329 - 119 -