PARKING l If the engine stops on a slope, apply the brake quickly and care- fully. Next, lower the work equip- ment to the ground and apply the parking brake. Then put the direc- tional and speed control levers in neutral, and start the engine again. l Before starting towing opera- tions, make sure that no one is near the machine. Start the ma- chine slowly to take up the slack in the wire rope. Then start towing carefully. Do not tow any machine whose brakes or steer- ing have broken down. l When parking the machine, park it in a safe place outside the working area, or in the specified place. The following factors should be considered when choosing a parking place:
it should be on flat, firm ground where there is no danger of rock- l Be careful when traveling on planks or steel plates, as these can cause slippage. falls, landslides or floods. l If the machine has to be parked on a slope, it should be parked facing directly up or down the l When operating at night, remem- ber the following points: o Be sure to arrange an adequate lighting system. o At night it is very easy to make mistakes in assuming the dis- tance and height of objects and land. slope, and chocks should be placed under the tires. l When leaving the machine, always lower the work equipment completely to the ground, and put all control levers in neutral.
Next, apply the parking brake and lock all levers. Then put blocks under the tires. l Before towing operations, always check the wire rope. l After stopping the engine, always remove the starting key. W-03208 -7-