Komatsu — PRECAUTIONS FOR MAINTENANCE

PRECAUTIONS FOR MAINTENANCE PRECAUTIONS FOR MAINTENANCE GENERAL BEFORE MAINTENANCE Before starting work, stop the machine on a firm, level surface, and use blocks to keep the ma- chine from moving during operations. Wear well-fitting helmet, safety shoes and working clothes. When drilling, grinding or hammering, always wear protec- tive goggles. When working with others, choose a group leader and work according to his instructions. Do not perform any maintenance beyond the agreed work. Hand a caution sign in the opera- tor’s compartment (for example “Do not start” or “Maintenance in progress”). This will prevent anyone from starting or moving the machine by mistake.

Always keep the work shop in good condition. Make sure there is no mud or oil on the floor. Keep oily cloths and other com- bustible things in a safe place away from fire. In addition, learn the location and method of oper- ation of fire extinguishers. Always stop the engine before cleaning the machine or adding fuel. Lower the bucket to the ground. If this is impossible, use the safety pin and blocks to hold the work equipment securely in position. In addition, apply the locks to all control levers. Always lock the front and rear frames before inspecting and ser- vicing the machine. (In articulate frame model) Remove all oil and mud from the machine.

In particular, be sure that the steps, hand grips, and the floor of the operator’s com- partment are clean. Always use the standard ROPS equipment. Do not modify the ROPS equipment. Flame should never be used in- stead of lamps. Never use a naked flame to check leaks or the level of oil, fuel, anti-freeze or electrolyte. l Always use non-inflammable cleaning agents when cleaning parts. Smoke only in designated places. Never smoke while working. -8- w-01317