Komatsu — BUCKET OPERATION

BUCKET OPERATION 6. If there is too much material l When digging and loading on level ground, set the bucket edge facing down slightly as follows and drive the machine forward. Always be careful not to load the bucket on one side and cause an unbalanced load. This operation should be carried out in 1 St gear. Set the edge of the bucket facing slightly down. 2. Drive the machine forward and operate the lift arm control lever forward to cut a thin layer of the surface each time when excavat- ing the soil. loaded in the bucket, dump and tilt the bucket quickly to remove the excessive load. This prevents spillage of the load during hauling. * 1. 3.

Operate the lift arm control lever slightly up and down to reduce the resistance when driving the machine forward. W-03820