BUCKET OPERATION 3. When the material is in a stock- pile, keep the cutting edge of the bucket horizontal; when loading blasted rock, have the bucket tilt- ing slightly down. * Be careful not to get blasted rock under the bucket. This will make the front tires come off the ground and slip. * Try to keep the load in the center of the bucket; if the load is on one side of the bucket, the load will be unbalanced. 4. At the same time as thrusting the 5. Check that there is enough mate- bucket into the material, raise the rial loaded into the bucket, then lift arm to prevent the bucket operate the bucket control lever form going in too far.
By raising to tilt the bucket and load the the lift arm, ample traction will be bucket fully. produced by the front tires. * If the bucket edge is moved up and down while pushing in the bucket and digging, the front tires will come off the ground and this will cause the tires to slip. Blasted rock W-03819 - 13-