DRIVE MOTOR 2.11 Removal 1 Remove any attachment, raise the boom arms and engage the boom support pins. 2 Raise the loader securely off the ground. 3 Remove the wheels on the side to be repaired. 4 Drain the oil from the final drive housing. Be pre- pared to contain approximately 17 litres (4.5 gal) of fluid. (fig. C1888) 2 Upper fill check Oil drain plug WARNING C3489 To prevent personal injury do not work under the boom arms without the boom supports engaged. Inspection cover 5 Remove the seat and hydrostatic shield. 6 Remove the final drive inspection cover located between the axles of the final drive housing.(fig. C3489) 7 Disconnect the chain as outlined in Section 3.
C3489 8 Remove the 2 high pressure hoses from the drive motor. ( fig. C3490 ) Cap the open hose ends and fittings to prevent contamination. Hi - pressure hoses IMPORTANT When making repairs to the hydraulic system, keep the work area and parts clean. Use caps and plugs on all open line and ports. C3490 9 Disconnect the 2 brake line hoses and cap the hoses and adapter fittings in the drive motor. (fig. C3490) 10 Remove the adapter fittings from the drive motor. Plug the open ports in the drive motor to prevent contam - ination. Brake hoses C3490 2-28