MAINTENANCE PLAN 4.7.1.d CLEANING THE WATER SEPARATOR 4 1 3 2 RWA19770 149 The water separator can be reached after opening the engine hood (see “3.5.1 ENGINE HOOD”). To clean the water separator, proceed as follows: 1 - Loosen the screw (1) and drain the fuel contained in the wa- ter separator, collecting it into a container with suitable ca- pacity. Use a 13 mm spanner. 2 - Loosen the central screw (2) and remove the cup (3) and the filtering element (4). Use a 14 mm spanner. 3 - Clean the inside of the cup and the filter with diesel oil or oil. 4 - Put back the filter (4) and the cup (3), tighten the screws (2) and (1) and bleed the fuel supply circuit as recommended for the fuel filter.
(See “4.7.11.e CHANGING THE FUEL FILTER”). 5 - Close the hood and start the engine. IMPORTANT • If the filtering element is clogged or damaged, change it.