. OPERATION OPERATION If the preheating time is too long or too short, the engine will not start easily. Observe the correct preheating time. 2. When the preheating is completed, turn the key in starting switch (2) to the START position to start the engine. 3. When the engine starts, release the key in starting switch (2). The key will return automatically to the ON position. 4. Continue to run the engine at idling for 15 seconds after starting. During this time, do not operate the control levers or fuel control lever. 3 - 66 MANUAL PREHEATI NG (3) to position I or II. p during the preheating operation. 1. 1.
Turn glow switch (3) t o position Lamp (4) lights u p during the preheating operation. When the preheating i s completed, r elease the switch. The key will then r eturn a utomatically to the following position. From position I, i t will return to A UTO From position II, it will return to OF The pre-heating time s are as show n below. Ambient temperature Preheat time 0°C to -5°C (32°F to 23°F) - -5°C to -10°C (23°F to 14°F) 15 seconds -10°C to -20°C (14°F to -4°F) 30 seconds -20°C to -30°C (-4°F to -22°F) 45 seconds