. OPERATION OPERATION OPERATION OPERATION ADJUST AMOUNT OF TILT Angledozers only WARNING REMARK 3. Tighten set bolt (1). 3 - 91 3. Insert arm (2) into the desired position on the bra cket on to p of the frame (3 places o n each side), and insert pin s (1) . When adjusting the amount of tilt, it is dangerous if the wo rk equipme nt is moved by mistake. Set th e work equipment in a safe condition, then stop the engi ne and lock the work equipme nt securel y with the work equipment lock NOTICE The maximum amount of tilt i s 400 mm (15.8 in). Be sure no t to exceed 400 mm (15.8 in). 1.
Raise the blade 400 to 500 mm (15.8 to 19.7 i n) above the ground, then put block s under the frame so that th e blade d oes not come down. 2. Loosen the bolt (1) of the brace, insert a suitable bar into h ole (2) of the brace, and t When turning the brace wi th bar, keep the blade abov e the ground. Right tilt: Make right s ide shorter, left side longer Left tilt: Make left sid