Komatsu — LOADING, UNLOADING WORK

. OPERATION TRANSPORTATION LOADING, UNLOADING WORK WARNING When loading or unloading, always use ramps or a platform. Proceed as follows. the trailer and put blocks under ° . 3 - 103 Since loading and unloading of th e machine is dangerous, be extremely careful. When loading or unloading the ma chine, operate it slowly with the engine speed low and the trans Use ramps having sufficient width , length, thickness, and strength. Install them securely and set t If the ramps are deflected apprecia Perform the loading work of the ma chine on firm, level ground. Secure sufficient distance between t he shoulder of the road and the trailer.

age of the machine so that the machine will not slip sideways on the ramps. In addition, il, etc. from the ramps. Remove mud from the undercarri remove water, snow, ice, grease, o Never steer the machine on the ra mps, since steering on the ramps can cause the machine to ti p over. If it is necessary to change the travel direction, return to the ground or to the bed of the trailer, then change the travel direction. railer, and the machine is The center of gravity of the mac hine shifts suddenly at the border unbalanced and becomes dangero LOADING WORK 1. Load and unload on firm leve Maintain a safe distance from 2.

Properly apply the brakes on the tires to ensure that the tra Make the slope of the ramps 3. Start the engine. In a cold weather, carry o ut an engine warming-up run, referring to the section, "ST ARTING IN COLD WEATHER . lever to the FREE position. (PAGE 3-71)", in this manual 4. Set the work equipment lock 5. Raise the blade. 6. Set parking brake lever to the FREE position. 7. Set the transmission in the 1s t gear and run the engine at low idle. d the ramps and drive slowly. 8. Set the travel direction towar 9. The center of gravity of the machine shifts suddenly at the border between the ramps unbalanced and becomes da border slowly. and trailer, and the machine is ngerous.

Accordingly, pass the ified position on the trailer. 10. Stop the machine at the spec