. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE have any defect, replace with new one. 11. Close the left engine side cover. 4 - 19 5. Direct dry compressed a ir (Max. 0.69 MPa (7 kg/cm2, 99.4 PSI)) from the inside of the direct the compressed air again from the inside. 1) Remove one seal from has been cleaned. 2) Replace the outer ele repeatedly or used th element at the same t 3) Replace both inner an cleaned outer elemen 4) Check inner element outer element along its folds.
Then from the outside along the folds, and the element whenever the element ment if it has been cleaned 6 times d outer elements when the dust indicato r red p iston appea rs soon after installi ng the t even though it has not been cleaned 6 times mounting nuts (8) for looseness and, if necessary, retighte 6. If small holes or thinner p arts are found on the element when it is checked by shining a light through it after cleaning, replace the element. NOTICE When cleaning the element, do not hit or beat it against anything. Do not use an element whose folds, gasket or seal are damaged. ight through it after cleaning, replace When cleaning the element, do n Do not use an element whose fol 7.
Install the cleaned elemen t and secure it with wing nut (5) and seal washer (4). If seal washer (4) or thre ads of wing nut (5) are damaged or 8. Remove the evacuator va lve (11), clean with dry compressed air and th en reinstall it 9. Install the cover (3). 10. Press the button of dust in dicator (1) to return the red piston to its original position.