. MAINTENANCE SERVICE PROCEDURE 4 - 23 8. Replace th e corrosion r esistor, the n open 2 v alves For details CARTRIDG E (PAGE 4 9. Close drain valve (2), ( 10. Add coolan t mixed with antifreeze until it overflow s from t he water filler. Decide the proportions of antifreeze and wate r according t o the tabl e for the mixing rate of wate r and anti freeze. 11. To remove air in the co oling syste m, run the engi at dle, then fo minutes (While doin g this, leave the radiato r cap removed. 12. Drain the c oolant from sub-tank ( 4), clean t he in side sub-tank, th en add wat er until the c oolant lev el is b etwee n the FULL and L OW marks. 13. Stop the en gine, wait f or approx.
3 minutes, t hen add coolant until the co olant level is near the co olant filler port, and tighten the cap. Ch eck the coolant level an d add coolant if necessary.