. MAINTENANCE SERVICE PROCEDURE CHECK IDLER OIL LEVEL WARNING INSPECTION 1. Remove bolt (1), then remove guide plate (2) and shim (3). 2. Loosen plug (4) slowly. If oil oozes through the threads at this time, the quantity of oil is sufficient. Tighten plug (4). 3. If any oil does not flow out when plug (4) is removed, the quantity of oil is insufficient. In this case, ask your Komatsu distributor for repair. 4. Install guide plate (2) and shim (3) with bolt (1). 4 - 34 If the oil level in the idler is low, n ew oil must be added, and the machine body must be inclined in this case. Since this work is dangerous, ask your Komatsu dis tributor.
If the oil level in the idler is low , noise will be generated and there will be seizure, so che ck the oil level and add oi as follows. REMARK When removing shim (3) keep it in a safe place and be careful not to lose it. REMARK When installing guide plate (2), install the same number and ved in Step 1. thickness of shim (3) as remo The optimum clearance may made at the same time. For de be obtained, if the adjustment is tails of adjusting the shim thickness, see "ADJUST IDLER CLEAR ANCE (PAGE 4-34)". ADJUST IDLER CLEARAN CE move forward and backward by an external force guide plates will be worn out.
Since the idlers are forced to move forward and backward by an external force guide pl ates will be worn ou Wear of these plates will caus e the vibration of idlers from side to side or inclination of th e idlers, and runnin g off of track links from the idlers or u nevenly worn idler and links may result. cording to the following procedure. Therefore, adjust the idlers ac cording to the following procedure. ADJUSTMENT 2 m (3.3 to 6.6 ft) on a level place, 1. Move the machine by 1 to then measure clearance guide plate (at four places 2.
If the clearance (A) excee and pull out the shim to ad to 1.0 mm (0.02 to 0.04 in Thickness of one shim is (A) between the track frame and of both sides, inside, and outside). ds 4.0 mm (0.16 in), loosen bolt (1), just the clearance at one end to 0.5 ). 1.0 mm (0.04 in).