Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE 4 - 35 PROCEDURE FOR BLEEDING AIR IN HYDRAULIC SYSTEM See "STARTING ENGINE (PAGE Since the engine must be started a nd the blade mus t be oper ated, see O PERATION. NOTICE If the engine is run a t high speed immedi ately after startup o r a cylinde r is pushed up to its stroke e nd, air take n inside the cylinder may cause damage to the piston packin 1.

Bleed air from left pitch cylinder (Powertilt, Po wer pitch dozer o Bleeding air f rom the hydraulic making the re 1) Bring the blade to the RAIS n the eng ine under no load at low 2) Bleeding air in the tilt hydra ulic circuit by repeating left and right tilt operation fi ve to ten 3) Bleeding air from the botto m of left cylinder by operat ing the blade to pitch forward and backw ard 5 to 10 times rep eatedly.

4) Set the le ft and right cylind ers at the neutral position, then carry ou t the followi ng operations 5 t o 10 times to bleed t he air from the he ad end of the left pitch cyli d when r emoving and installing th quipme nt or when (1) Forwa rd pitch → (2) Lef t tilt → (3) Right ti lt → (4) B ackward pitc 2. Bleeding air f 1) Run the e ngine at low idle, and extend and r etract eac h cylinder 4 to 5 times, t aking car e that a cylinder is not move d to the end of its stroke. (Stop the cylinder a pprox. 100 mm (3.9 in) s hort of it s stroke end) 2) Next, ope rate each cylinder 3 to 4 times to th e end of its stroke.

3) Finally, o perate each cylind er 4 to 5 times to the end of its stroke t o completely remove the air.