. MAINTENANCE SERVICE PROCEDURE METHOD OF ADJUSTING EACH LOCATION ADJUSTING SHIMS AT TILT BRACE, TILT CYLINDER HEAD, PITCH CYLINDER HEAD 4 - 38 Correct value for play a t ball joint: 0.2 - 0.7 mm Standard shim thicknes Use the following procedu re to adjust the play at the ball joint to th e correct v alue 1. Remove bolts (1), the n remove cap (2). nd dirt from the sliding surface of ball (3). ten bolts (1) temporarily. torque: 19 .6 to 29.4 Nm (2 to 3 kgm, 14.5 to 21.7 lbft) portion A (top) and portion B (bottom) of ball joint, and calculate average clearance C ickness is (C + 0.2) - (C + 0.7) mm. n be set in units of 0.5 mm. n remove cap (2).
shim measured in Step 5, then tighten cap (2) fully with bolts (1). to 565 Nm (46.5 to 58 kgm, 336.3 to 419.5 lbft) 2. Wipe off the grease a nd dirt from the sliding s urface of ball (3) 3. Remove all shims (4). 4. Install cap (2) and tigh ten bolts (1) temporaril Temporary tightening torque: 19 .6 to 29.4 N m (2 to 3 kgm, 14 .5 to 21.7 l 5. Measure clearance at portion A (top) and por tion B ( bottom) o f ball joint, and calculate average clearance [C = (A+B)/2]. Set so that the shim th ickness is (C + 0.2) - ( C + 0.7) The shim thickness ca n be set in units of 0.5 6. Remove bolts (1), the 7.
Install the thickness of shim measured in Ste p 5, the n tighten cap (2) full y wit h bolts (1 Tightening torque: 455 to 565 Nm (46.5 to 58 kgm, 3 36.3 to 4 19.5 lbft 8. Before filling with grea se, operate the work e quipmen t and ch eck that there is no abno rmal noise or abnormal play. gh the grease fitting of the ball joint. ff any old grease that was pushed out. 9. Pump in grease throu gh the grease fitting of the ball 10. After greasing, wipe o ff any old grease that w