Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE ADJUSTING SHIMS AT TRUNNION 4 - 41 Correct value for play at ball joint: Use the following procedure to adjus t the play at the ball joint to the correc 1. Remove bolts (1), then remove c ap (2). the sliding surface of ball (3). 1) temporarily. 2 to 49 Nm (4 to 5 kgm, 28.9 to 36.2 lbft) 2. Wipe off the grease and dirt from 3. Remove all shims (4). 4. Install cap (2) and tighten bolts ( Temporary tightening torque: 39. 2 to 49 Nm (4 to 5 kgm, 28.9 to 36.2 l bft) 5. Measure clearance at portion A ( top) and portion B (bottom) of ball join t, and calc ulate avera ge clearance [C = (A+B)/2]. (C + 0.2) - (C + 1.2) mm. units of 1 mm. ap (2).

sured in Step 5, then tighten cap (2) fully with bolts (1). and bottom to reach the specified torque. m (80 to 100 kgm, 578.6 to 723.3 lbft) check that there is no abnormal noise or abnormal play. Set so that the shim thickness is The shim thickness can be set in 6. Remove bolts (1), then remove c 7. Install the thickness of shim mea sured in Step 5, then tighten cap (2) f ully with bo Tighten bolts (1) in turn at the top and bottom to reach the specified torque Tightening torque: 785 to 980 N m (80 to 100 kgm, 578.6 to 723.3 lbft) 8. Operate the work equipment and check that there is no abnormal nois e or abnor