. MAINTENANCE SERVICE PROCEDURE CHECK FAN BELT TENSION, ADJUST ADJUSTMENT the in) 4 - 52 INSPECTION Deflectio n "a" shou ld be 6 to 10 mm (0.2 to 0.4 in) when the be pressed with a fing er force of approx. 59 N (6 kg) at a point mid between the altern ator pulley and fan p ulley. 1. Loosen bolts a 2. Turn nut (4) clo ension so to adjust belt t s approx. 10 when pushed w ith a force of approx . 59 N (6 kg) 3. Tighten the bol and (3) to fix alternato n REMARK Check each pull ey for breakage and wear of the V-groove. In particular, check that th e V-belt does not touch the botto m of the V- groove. ty is found, ask your Komatsu distributor for replacement of the pulley.
o lengthened that it cannot be adjusted any more or if it has any cuts or cracks, replace it. If any abnormali ty is found, ask your Komatsu distributor fo r replacement of the pull If the V-belt is s o lengthened that it c annot be adjusted an y more or if it has any cuts When adjusting the V-belt, do not pr ess the alternator direc tly with a bar, but put a w ood piece, etc. in-between them. If the V-belt has been replaced with a new part, there will be initial elongation, so insp ect and adjust it again after one-hour of ope ration.