Komatsu — OPERATION

. ATTACHMENTS, OPTIONS HANDLING HYDRAULIC RIPPER OPERATION CHECK BEFORE STARTING ENGINE, ADJUST WALK-AROUND CHECK ADJUSTING POSTURE OF WORK EQUIPMENT 6 - 5 1. Check for wear of the p oint at t he tip o f the shank, ch eck the mounting condition, and c heck for damage to the rivets. If a ny problem is found, replace or repai PRECAUTIONS WHEN OPERATING Travel in lo w speed and lower t he ripp digging de pth is reached , move the con trol lever to th e HOLD position. Do not dig the shank in d eep when star ting digging op erations During ripp ing operation s, neve r turn t he machine s uddenly or travel in suddenly o r traveling in r everse , raise t he shank from the ground surface.

When carr diggi shank, the shanks. When start ing to travel up a stee p slope or when r eachi ng the bottom o f the slope , the poin t may touch the gr ound. On hard gr ound, there is danger of the p oint breaking if it touches the ground, so raise the shank to the maximum height. ADJUSTMENT OF DIGGING DEPTH There are mo unting holes f or the p in in th e shank. Selec t the mounting hole to match the d igging depth. Pin hole position Use Max. digging depth mm (in) (A) t When there is special need o dig deeply 595 (1' 11") (B) Normal 485 (1' 7") (C) When not using ripper -