CONTROLLER CURRENT CONDITION CHK2 Continued Swing Park Brake High Speed Travel Travel Alarm Power Boost This screen can be used to verify that the controller is sending a signal to the circuits listed. TRANSISTOR OUTPUT (0=OFF, 1=ON) Start the engine and engage lever lock (pilot pressure). Swing Park Brake - Move the swing hand control just enough to close the swing pressure switch. Should see the 1 change to 0. Return the hand control to neutral. The 0 should change to 1 after 5 seconds. Slowly raise the boom until screen indicates swing brake is turned off. Return boom control to neutral. Swing brake should be turned on 5 seconds later.
High Speed Travel & Travel Alarm – Press the travel switch to select high-speed travel. The high speed travel field should change to a 1 and to 0 when the switch is pressed again. Move a travel foot control just enough to close the travel pressure switch. Should see the alarm field change to a 1 and change back to 0 when the foot control is released. Power Boost CX210/CX240 -Move one of the attachments to end of stroke. As the pressure increases the power boost field should change to a 1 as the Auto Power Boost is engaged. Power boost should be on for 8 seconds. Select L mode with the Work mode switch. Power boost should be turned on until another work mode is selected.
Power Boost CX130/CX160 – Press the one-touch switch on the front of the right hand control. The power boost field should change to a 1 for 8 seconds. Select L mode with the Work mode switch. Power boost should be turned on until another work mode is selected. 3 - 15 CX EXCAVATORS TR1 0 0 0 0