ELECTRICAL 4 - 2 CX EXCAVATORS RPM CONTROL Operation Function Explanation Throttle Motor (CX130/CX160) 1) Engine speed on the CX130/CX160 excavators is adjusted with a stepper motor. 2) The stepper motor is controlled by the controller through the throttle driver. 3) The throttle motor requires calibration. See pages 2-3 Engine RPM Control 1) Engine speed on the CX210/CX240 excavators is controlled by the engine controller. See pages 6-7 Idling Control 1) The operator can select one touch idle, or he can select auto idle. 2) Auto idle time can be programmed from 1 to 30 seconds. See pages 8-9 RPM Control for Each Mode (H,S,L, and Auto) 1) Maximum rpm is obtained by selecting H mode.
2) S mode speed is 200 rpm less than H mode. 3) L mode speed is 300 rpm less than H mode. 4) Auto mode speed varies between S mode speed and L mode speed 5) Idle speeds are stored permanently in the controller memory See pages 10-19 Engine Auto Warm-up Increases engine rpm by steps over a 15 minute period if: 1) Water temperature is below 50°C 2) Hydraulic functions or throttle are not operated for 12 seconds. 3) One touch idle is off. 4) If the throttle is moved or any hydraulic function is operated, auto warm-up is canceled. See pages 20-21 Breaker Revolution Control 1) When the breaker pressure switch is hydraulically closed, the engine rpm will decrease to a preset speed.
2) The throttle control knob speed setting must be set higher than the preset speed. See pages 22-23