International Trucks — International VT 365 Diesel Engine Service Manual 2004-2006

ELECTRONICALLY CONTROLLED VARIABLE GEOMETRY TURBOCHARGER (VGT) 67 Installation Variable Geometry Turbocharger (VGT) and Components Figure 67 Lubrication for O-rings on oil drain tube for VGT Figure 65 VGT bracket 3. Install two new oil drain tube O-rings and lubricate both O-rings with clean engine oil. 4. Remove cap and install drain tube in the high-pressure oil pump cover. 1. Place VGT bracket in engine valley by putting right side of bracket under EGR cooler coolant inlet tube. Then lower left side over bolt holes. NOTE: If not immediately installing the VGT, install a cover over the oil drain tube. Figure 66 VGT bracket bolts 2.

Install four M8 x 20 mounting bolts to secure VGT bracket to crankcase. Tighten bolts to the standard torque (Standard Torques, page 375). Figure 68 VGT alignment dowels and bosses 1. Alignment dowel 2. Alignment boss EGES295-2 Read all safety instructions in the "Safety Information" section of this manual before doing any procedures. Follow all warnings, cautions, and notes. ©2006 International Truck and Engine Corporation