SECTION 5 MAINTENANCE Page 24 5.8. COOLING SYSTEM 5.8.4. RADIATOR 5.8.4.1. Radiator Cap Fig. 5.8. Radiator Cap General The radiator cap seals the coolant filler opening of the radiator. Positive sealing requires a cap gasket and its contacting surfaces in good condition, and a properly tightened cap. The radiator cap incorporates a pressure relief valve that keeps the pressure of the coolant at 40 – 55 kPa in top tank of the radiator. NOTE: Operating the machine without a radiator cap, or with a cap without a relief valve set to operate at the correct pressure can cause damage. Removal WARNING! Hot, scalding coolant can spray out if the radiator cap is removed suddenly.
Relieve system pressure by slowly turning the cap to the first notch or lifting the safety lever. Remove the cap only after the pressure is relieved. WARNING! Use extreme caution when adding coolant to a hot radiator to avoid being burned. Wear gloves and goggles and keep face away from the filler neck. To remove the cap turn the cap to the left or counterclockwise up to the safety stop until all pressure is released. Then press down on the cap and continue to turn until the cap is free to be removed. TD-40C DRESSTA